[screenman]

Dryout

As most of you know we have some wet days over here, so dry out is high on our agenda. The latest method we have that seems to work is what we now call the micro vibrate method. Warm the damage around the break to an area of about 32 mm. Then place 2 fingers one from each hand either side of the damage and then vibrate very gently for about 3 minutes. Then reheat and repeat the process, this may take a few attempts to remove all moisture. The vibration when done correctly massages the sponge in the PVB and helps the moisture evacuate the area. Pushing to hard will damage the break and trap the moisture at a lower level. If it is possible to have a co-worker or the customer vibrating from the inside at the same time this may speed drying times up. This supersedes our blow out method.