Rain-X Problems

Post your windshield repair tips, questions, advice! Note there is a sub-forum specifically for business development questions.

Rain-X Problems

Postby crackhead » November 20th, 2004, 5:27 pm

Has anyone else experienced problems associated with Rain-X or other rain repellents that customers use on their windshields? Sometimes I have problems with it pushing resin back out and leaving black edge lines, etc. Any advice on how to keep this from happening?

Senior Member
Posts: 1951
Joined: November 12th, 2003, 6:11 pm
Enter the middle number please (3): 5
Location: Southern California
Been thanked: times

Re: Rain-X Problems

Postby GlassStarz » November 21st, 2004, 10:36 am

If you know the glass has been treated drill to the break leave the injector on and pressure cure. When ready to fill pit take the drill and burr the inside of the pit ruffing up all the edges then apply the pit resin after all this do Native American rain dance say a couple hail marys to seal the deal and remove cure tab and scrape as normal with fingers and toes crossed


Re: Rain-X Problems

Postby CPR » November 21st, 2004, 4:55 pm

I just carry a can of acetone and clean every break with it, just assume the ws is treated, clean it and you wont have any problems after the repair.

Return to “Windshield Repair”

Who is online

Users browsing this forum: No registered users and 2 guests