Glas-Weld o-rings & seals

[sunshine wr]

Anyone know a place to get upper piston seals for Pro-Vac 2000, besides GW @4.95 each????? Thanks.

[Glassdoc]

White Injector Seals

Replacements for the external seals on all our injectors and the internal seal of our stone chip injectors.
(10 pack)
$10


Red Injector Seals

Replacements for the internal seal of the crack injector
(replaces black o-rings).
(5 pack)
$3.50
http://www.windshieldrepair.com/catolog/red%20seals.jpg
http://www.windshieldrepair.com/supplies.htm

[sunshine wr]

Thanks for the info. I was looking for these. They have gone up now $7.95 each. http://store.glasweld.com/ProductInf...d=SEALUPPIST20

[souchie]

It's $7.95 for a pack of 2 not $7.95 each.

[sunshine wr]

Sorry! they were $4.95 a pair. Anybody got answers to post #1 ?

[tooldini]

I doubt you will be able to get them anywere else. When did you get them for $4.95 a pair? I have been getting them for 5 years and have never seen them that cheap. I just got some last week for $7.95 for two they are always sold in packs of two. Wish I knew of a cheaper place to get them myself.

Jeff

[screenman]

How much does it cost per job to run your tools and consumables? Mine work out at about 50p or $1 per repair this is averaged across the year. I find a better way to save money is to drive a more economical vehicle.

[sunshine wr]

I think post #7 may need to moved to a different thread, sense it has nothing to do with the question in this one.

[screenman]

My point is, the overheads for this business are very low compared with many others. Give the guys like Glasweld a bit of profit, spend your time and effort finding one more chipped screen a week rather than worry about a very few cents. Give the manufacturers a break without them you would not have had a business in the first place, now would someone like to answer my question. There seems to be a lot of sniping on this forum that was not around a few yeras ago.

[sunshine wr]

The cost for me for this one seal is around 100.00 a year , that's for 7 injectors changing them about every 3 months or as needed. 7x3.98=27.86x4=111.44 to be exact. I know this isn't much, but saving $$ is one of the hats I have to wear for my company. If you watch out for the pennys the dollars will take care of themselves. Oh! by the way I do buy alot of supplies from Glas-Weld. I have seen this type of seal in other applications such as a low pressure garden spayer pump. Just can't seem to manufacturer. Thanks for your help.