I-100 Injector

[gt_repair]

Can anyone tell me if they have to I-100 injector and what do you think about it... And what bridge do most of you use also.....?
Are they any good for vetical repairs also?

[SGT]

We have (6) I-100 injectors in service and have been using them since there inception have been very pleased with there performance.

As for the verticle repairs, the DKI bridge and injector combination work just fine. Set up is slightly different though, which is key. With the larger diameter injector barrel, it allows the resin dropper to reach the tip of the injector as well.

Does you current tooling have verticle repair limitations? If so what are they?

[gt_repair]

Brian
As most of you know Ihave the GT system and use the Spectrum injector. I have been using the LR injector as posted in another thread before. I also have my 20/20's from GT that I could use a vertical adapter, but a pain in the back side and a lot of resin loss to use it..
Was looking at the Delta video they have on their web page. Is this a front load for vertical repairs?

[SGT]

The I-100 is not front/tip loaded. It is back end loaded once the bridge and injector are set in place. The I-100 has the capability of getting the resin to the tip due to the larg barrel diameter of the injector which allows the resin dropper, pipet style to reach the tip. I use just a few more drops of resin on verticle repairs but residual waste is minamal.

Set up is key as I would assume it is with any brand tooling. You will need a slight forward pitch to keep the resin at the tip.