Injector stuck in position

Post your windshield repair tips, questions, advice! Note there is a sub-forum specifically for business development questions.
Post Reply
Game and Watch
Junior Member
Posts: 1
Joined: February 15th, 2020, 4:32 pm
Enter the middle number please (3): 3
Has thanked: 0
Been thanked: 0

Injector stuck in position

Post by Game and Watch » February 15th, 2020, 4:38 pm

I have a Delta I-100 injector and it is stuck in one position, i can't get it to extend out. I think the last time i used it, i didn't clean out the residue resin and that's what causing it to be stuck. Do you guys know if there are any ways that i can get get rid of the old resin and get it to extend again?

Thank You

Kgobin
Moderator
Posts: 1102
Joined: June 5th, 2008, 11:03 am
Enter the middle number please (3): 3
Location: Champaign, IL
Has thanked: 2 times
Been thanked: 37 times
Contact:

Re: Injector stuck in position

Post by Kgobin » February 16th, 2020, 6:16 pm

Once resin is cured, you can't uncure it :(
I will send you an email on where to mail it to so we can see if we can fix it for you.
Korey Gobin
Delta Kits, Inc.
Image

sunshine wr
Senior Member
Posts: 622
Joined: August 13th, 2003, 5:53 am
Has thanked: 27 times
Been thanked: 19 times

Re: Injector stuck in position

Post by sunshine wr » February 17th, 2020, 5:00 am

This will break it down.
http://bsi-inc.com/hobby/un_cure.html

johnnyone
Member
Posts: 235
Joined: January 20th, 2004, 9:02 am
Enter the middle number please (3): 5
Location: Albuquerque NM
Has thanked: 14 times
Been thanked: 1 time

Re: Injector stuck in position

Post by johnnyone » February 22nd, 2020, 7:09 am

If you have any finger nail polish remover give that try. I would soak it for a few hours to see if it comes loose. Hope this helps.

RCRNR
Member
Posts: 143
Joined: July 20th, 2018, 3:18 pm
Enter the middle number please (3): 3
Has thanked: 31 times
Been thanked: 30 times

Re: Injector stuck in position

Post by RCRNR » February 23rd, 2020, 11:24 am

ooops

Post Reply

Who is online

Users browsing this forum: No registered users and 14 guests