I have a Delta I-100 injector and it is stuck in one position, i can't get it to extend out. I think the last time i used it, i didn't clean out the residue resin and that's what causing it to be stuck. Do you guys know if there are any ways that i can get get rid of the old resin and get it to extend again?
Thank You
Injector stuck in position
-
- Junior Member
- Posts: 1
- Joined: February 15th, 2020, 4:32 pm
- Enter the middle number please (3): 3
- Contact:
-
- Moderator
- Posts: 1107
- Joined: June 5th, 2008, 11:03 am
- Enter the middle number please (3): 3
- Location: Champaign, IL
- Contact:
Re: Injector stuck in position
Once resin is cured, you can't uncure it
I will send you an email on where to mail it to so we can see if we can fix it for you.
I will send you an email on where to mail it to so we can see if we can fix it for you.
Korey Gobin
Delta Kits, Inc.
Delta Kits, Inc.
-
- Senior Member
- Posts: 626
- Joined: August 13th, 2003, 5:53 am
- Contact:
Re: Injector stuck in position
This will break it down.
http://bsi-inc.com/hobby/un_cure.html
http://bsi-inc.com/hobby/un_cure.html
-
- Member
- Posts: 235
- Joined: January 20th, 2004, 9:02 am
- Enter the middle number please (3): 5
- Location: Albuquerque NM
- Contact:
Re: Injector stuck in position
If you have any finger nail polish remover give that try. I would soak it for a few hours to see if it comes loose. Hope this helps.
-
- Member
- Posts: 154
- Joined: July 20th, 2018, 3:18 pm
- Enter the middle number please (3): 3
- Contact:
Who is online
Users browsing this forum: No registered users and 43 guests