Page 1 of 1
Injector stuck in position
Posted: February 15th, 2020, 4:38 pm
by Game and Watch
I have a Delta I-100 injector and it is stuck in one position, i can't get it to extend out. I think the last time i used it, i didn't clean out the residue resin and that's what causing it to be stuck. Do you guys know if there are any ways that i can get get rid of the old resin and get it to extend again?
Thank You
Re: Injector stuck in position
Posted: February 16th, 2020, 6:16 pm
by Kgobin
Once resin is cured, you can't uncure it
I will send you an email on where to mail it to so we can see if we can fix it for you.
Re: Injector stuck in position
Posted: February 17th, 2020, 5:00 am
by sunshine wr
Re: Injector stuck in position
Posted: February 22nd, 2020, 7:09 am
by johnnyone
If you have any finger nail polish remover give that try. I would soak it for a few hours to see if it comes loose. Hope this helps.
Re: Injector stuck in position
Posted: February 23rd, 2020, 11:24 am
by RCRNR
ooops