Drill
-
- Senior Member
- Posts: 1951
- Joined: November 12th, 2003, 6:11 pm
- Enter the middle number please (3): 5
- Location: Southern California
Drill
I recently bought a Dremil 7.2 have been useing it a couple weeks like it alot $39 at wally world
Re: Drill
A few years ago I had a consistent problem with several of my dremel batteries not holding a charge for long.Ultimately I called the manufacturer and they asked if I charged them longer than three hours;Sure enough, a lot of times i would leave for the day and leave the batteries on charge.I bought new batteries,and a plug-in timer and started plugging the charger into the timer, setting it for three hours and that took care of my problem.
-
- Member
- Posts: 124
- Joined: February 2nd, 2005, 7:06 am
- Enter the middle number please (3): 5
- Location: Vermont
- Contact:
Re: Drill
We also have dremel battery drills, what we have found usefull, is to charge the batteries as we are driving to the next job. They sell power inverters that plug into cigarette lighters. They are great & inexpensive. That way we have a "full charge" at every job.
They too, are sold at "Wally World"
They too, are sold at "Wally World"
[FONT=Arial]A-1[/FONT] Windshield & Vinyl Repair
We get the monkey off your back! Since 1984
We get the monkey off your back! Since 1984
-
- Member
- Posts: 235
- Joined: January 20th, 2004, 9:02 am
- Enter the middle number please (3): 5
- Location: Albuquerque NM
- Contact:
-
- Member
- Posts: 286
- Joined: August 12th, 2003, 12:00 pm
- Contact:
Re: Drill
A1Repair... great tip, using timers for charging... I had known about over-charging the batteries, but invariably would forget to pull them after 3 hours. I never thought about using timers... and we have a number of those that only get used at Christmas time. Another thing that will shorten battery life is charging them before they are fully run down. Those batteries have a ''memory'' ... not sure I can explain it correctly... but if you re-charge a half-used battery... it remembers where it was charged to ... if you do this repeatedly ... say you charge at the end of the day even if the battery isnt all the way run down... eventually the battery will only be good for that amount of use... same thing happens with cordless phone batteries. The thing to do is let them get fully run down, then recharge them completely.
Re: Drill
The best drill I've found to date is Dremel Model 800, 10.8 volt/Lithium-Ion. It's a little pricey at $69 but has no memory to worry about and only requires charging once a month. For polishing I use the older version 7.2 volt/ni-cad dremel model and yes, you should always pre drain any ni-cad battery to zero between charging cycles. If you haven't been doing this and are experiencing charging problems, try running battery through 7-9 full charging and discharging cycles which should help erase these memory problems. I learned this from selling cellular phones with ni-cads for 7 years and 80% of the time it worked.
Who is online
Users browsing this forum: Bing [Bot] and 63 guests