Repair without drilling, tool needed?
- Charlie
- Junior Member
- Posts: 10
- Joined: June 11th, 2013, 12:24 pm
- Enter the middle number please (3): 3
- Location: Austin, TX 78741
- Contact:
Repair without drilling, tool needed?
If I am to repair without drilling the chip, won't I need a certain kind of probe that can etch into the glass correctly? I bought a carbide probe for this job, but now upon receiving it it looks like normal metal at the tip.. Do you know what the name of the probe is that I was thinking of? Thank you guys!
- Brent Deines
- Moderator
- Posts: 2449
- Joined: September 24th, 2003, 7:54 am
- Enter the middle number please (3): 5
- Location: Eugene, OR
- Contact:
Re: Repair without drilling, tool needed?
You don't need a special kind of probe to fill a break without drilling and most technicians prefer "not" to use a carbide probe because it is easy to accidentally scratch the glass. If you really want one I'm sure I can dig one up for you but I don't recommend it.
Brent Deines
Delta Kits, Inc.
Delta Kits, Inc.
- Charlie
- Junior Member
- Posts: 10
- Joined: June 11th, 2013, 12:24 pm
- Enter the middle number please (3): 3
- Location: Austin, TX 78741
- Contact:
Re: Repair without drilling, tool needed?
I was just taught to use the carbide when trying to fill w/o drill, and had never considered only using the steel probe. That's all I have now though and will try it out tomorrow!
- Charlie
- Junior Member
- Posts: 10
- Joined: June 11th, 2013, 12:24 pm
- Enter the middle number please (3): 3
- Location: Austin, TX 78741
- Contact:
Re: Repair without drilling, tool needed?
I guess what I have actually is a carbide. It looks super smooth though so it tricked me. I see what you were saying about using a regular steel probe, if you slip out it wouldn't mess up the glass.. I lost my steel probe somehow and also my rubber vacuum cup.. Would probably buy either from someone $
- Chips_Away_Windshield_Repair
- Member
- Posts: 189
- Joined: February 10th, 2004, 1:08 pm
- Enter the middle number please (3): 5
- Location: Tomball Texas and surrounding areas
- Contact:
Re: Repair without drilling, tool needed?
My opinion. I just use a carbide awl, lightly scratch a small indentation at the end of a crack to keep the burr from skipping.
Who is online
Users browsing this forum: No registered users and 39 guests