Drilling technique

Post your windshield repair tips, questions, advice! Note there is a sub-forum specifically for business development questions.
Post Reply
Jtmac
Junior Member
Posts: 29
Joined: August 10th, 2018, 5:23 pm
Enter the middle number please (3): 3
Contact:

Drilling technique

Post by Jtmac »

Could someone tell me the significance of starting your drill at 45 degrees and then raising it to 90 after you begin drilling? I've noticed this in several videos.
Nomad
Member
Posts: 283
Joined: December 11th, 2004, 3:13 pm
Enter the middle number please (3): 5
Location: Yuma Arizona
Contact:

Re: Drilling technique

Post by Nomad »

It's using the end of the burr to grind a pocket, a little dip in the glass, so that the drill will not skate around when you begin drilling.
Jtmac
Junior Member
Posts: 29
Joined: August 10th, 2018, 5:23 pm
Enter the middle number please (3): 3
Contact:

Re: Drilling technique

Post by Jtmac »

I don't use burr bits, so that explains it. Thanks.
Post Reply

Who is online

Users browsing this forum: Bing [Bot] and 19 guests