Keep Things Dry!

Post your windshield repair tips, questions, advice! Note there is a sub-forum specifically for business development questions.
toab

Re: Keep Things Dry!

Post by toab »

By principal a strong 25 inch vacuum should vaporize alot of miosture by signifiantly lowering its boiling point.Of course that depends on whether your tool can pull that much vac in the first place.I personally use both a little heat and vac'.
WIN-1

Re: Keep Things Dry!

Post by WIN-1 »

50 repairs in a Costco parking lot? They didn't have time to do a good job anyway!
YMMV
screenman
Senior Member
Posts: 3192
Joined: February 25th, 2004, 1:44 pm
Enter the middle number please (3): 5
Location: uk Lincolnshire

Re: Keep Things Dry!

Post by screenman »

mrchip,

I would not know what 90 degrees is like, when it rained the glass cooled, it then expanded as the temperature went up. Therefore causing the crack to close up slightly. On tests we have found that moisture can and will be in the legs of some starbreaks for a lot longer than one hour due to there being no way for it to escape, because of the expansion. Once again I state that is only in test situations.
33,000 + screen repairs over 18 years and still learning.
Over
mrchip

Re: Keep Things Dry!

Post by mrchip »

screenman.. its been 90 most of august with bright sun.. and when it rains its still 90 ..window doesnt get that cool.. i dont believe legs would stay closed up that long over here ..it only takes a very short time for glass to get back to normal..heat index has been over 100 many days..i know in the uk the weather is much more overcast and much more precipitation..i have closed up legs of stars with heat and it only takes a short while for it to come back
StarQuest

Re: Keep Things Dry!

Post by StarQuest »

I personally inspect all windshield damage prior to ever starting a repair and always look for signs of moisture present. If your not to the level in repair of identifying damage that has moisture in it, please either experiment with your practice shield some more by adding water to inhance your visual repair skills or simply just dry it out anyway to be on the safeside.

Although it may not have rained in days in your area or temps were high, please remember many customers have this need to wash their vehicle's prior to you showing up. Sometimes it's your dealers with wash guys. So...that means there could be water in the damage on any given day! What happens when you push water or moisture in the repair? For the first 2-3 weeks damage will look filled and cured but eventually that pushed moisture will evaporate, leaving the repair look unfilled.

Welcome your feedback.
L.R.

Re: Keep Things Dry!

Post by L.R. »

This Is A Little Off The Main Subject . But Would'nt A Store Like Costco Require Something From Those Tent Guys To
Conduct Buisness On There Parking Lot. You Would Think So
StarQuest

Re: Keep Things Dry!

Post by StarQuest »

L.R.,

I'm sure who ever is running this operation is paying some high premiums to be there. Like $200 plus per day! What I had seen during my 45 minute stay was 4 techs, one call person for insurance and a line of 8 to 10 vehicles waiting patiently to be serviced.

During my parked stay I had seen 15 cars being repaired. Figure out the math!
RVB
Junior Member
Posts: 16
Joined: August 17th, 2006, 5:14 am
Enter the middle number please (3): 5
Location: Florida

Re: Keep Things Dry!

Post by RVB »

This needs to become a habit, and part of the process. I am very constant about drying before starting. However, today (first repair of the day) I committed the mortal sin. Yes I did it. Right after I started the pressure cycle I realized what I had done. The end result came out good, but it should be better. It was supposed to be the perfect repair, and it didn
Post Reply

Who is online

Users browsing this forum: No registered users and 53 guests