Windshield Repair Forum

$100 per year thats only two repairs. I understand about saving money but there is a cost to do any buisness. The cost associated with this segment of the reconditioning industry is relatively low compared to others such as Paint repair wich is 12-18% of your job is tied up in consumables

You can get the seals for the regular ProVac and the 2000 from MARTIN FLUID POWER CO. the part # for the Reg. upper seal is BV-0062-4BN80 they cost around $1.35 each and they work great.The upper seal for the 2000 is part #BV-0075-4BN80 they cost about the same,these seals fit tight but if you take your time seating them in the injector and lube them well they work
just fine.
O,I guess you would like the ph#. In Texas the number is 713-939-9990. They have several locations,MI,OH,GA,AZ.Hope this helps.

Did you peeps not see this post? A dollar a piece for the white seals, and .70 cents for the black o-rings..

Glassdoc;25437 wrote:White Injector Seals

Replacements for the external seals on all our injectors and the internal seal of our stone chip injectors.
(10 pack)
$10


Red Injector Seals

Replacements for the internal seal of the crack injector
(replaces black o-rings).
(5 pack)
$3.50
http://www.windshieldrepair.com/catolog/red%20seals.jpg
http://www.windshieldrepair.com/supplies.htm

Glassdoc,yes we peeps saw that post,but the seals they are asking about are the upper piston seals, if you don't have a Provac then you must not know which seals we are talking about.Souchie
By the way I have been getting the other seals from "windshield repair.com "for the last couple of years.

Wow..thanks souchie.. I used my last upper seal today and was about to order ..i will call texas tomorrow

Souchie, Thanks for an answer to the to the actual posted question.

Always glad to help!

Hey souchie..THANKS AGAIN!!!!...I recieved the upper seals today and they fit and work great..cost was $1.37 each..a whole lot cheaper than GW..You made my day