Windshield Repair Forum

I'm with screenman on this.I would have responded the same as he did.With him being a veteran on this forum I have found from past experience when I was learning this craft a couple of years ago that following his advice/techniques usually produced the desired results.In other words my techniques were sometimes learned "copied" from him and a few other longtimers on this forum.Thanks Screenman.

I do the same as screenman and additionally cover a leg with a drop of very thin resin and a tab immediately after a 1 second burst of heat from the inside when on vacuum then put on pressure and the very thin spidery line that sometimes shows after a fill disappears.
I will definitely be trying an electric toothbrush to see if it helps!
Very interesting thread!