Posted: August 9th, 2004, 10:56 pm
Good Morning
This old question has reared it's ugly head once again. I have had a few queries regarding the hardness of Delta seals. I am refering to the white ones that seem extremely hard for the first half dozen or so uses. Up till now I usually recommend either using the tip of the injector piston to help loosen them up a bit or even on occasion leaving them for a few hours in a pot of resin. Both help a little but I would be interested to know what others find works best.
Regards
Eric Howe
Optic-Kleer
England
This old question has reared it's ugly head once again. I have had a few queries regarding the hardness of Delta seals. I am refering to the white ones that seem extremely hard for the first half dozen or so uses. Up till now I usually recommend either using the tip of the injector piston to help loosen them up a bit or even on occasion leaving them for a few hours in a pot of resin. Both help a little but I would be interested to know what others find works best.
Regards
Eric Howe
Optic-Kleer
England