Page 1 of 1
gm thick resin
Posted: April 13th, 2006, 4:25 pm
by phils windshield repair
im in michigan for some reason i have 8 ounces of thick resin from gm what is this resin good for and can u also dilute thick resin with starfill ty for your input
Re: gm thick resin
Posted: April 13th, 2006, 6:16 pm
by GlasWeldTech
You may want to try it in Bullseyes. Nothing with tight legs in it.
Re: gm thick resin
Posted: April 13th, 2006, 6:49 pm
by toab
Seems to me that the thick stuff is also recommended for crack work due to its inherant higher strength and closer R.I. to glass when cured.I am having some luck starting long cracks with thin resin and then adding the thick stuff to the injector after the first few inches where the crack is easier to fill.But I am just a newbie so the veterans may correct me on my technique.When I was snooping around the internet about the .
Re: gm thick resin
Posted: April 14th, 2006, 7:37 am
by dragwurm
thick resin is relly used for a high temp repairs. its good for bullseye and combos where the legs dont pass the coned area, :eusa_droo
Re: gm thick resin
Posted: April 14th, 2006, 9:11 pm
by toab
High temp meaning summer time or meaning when using heat on the repair?
question
Posted: April 14th, 2006, 9:41 pm
by phils windshield repair
can u thin out gm thick resin ty 4 input?