Page 1 of 1

Needle for making be

Posted: April 16th, 2006, 1:46 am
by ChipRite
Hi,
Can anyone give me more info on using a needle for making a small bullseye. Presently I am using a very thin probe with a flat point, but these are scarse and difficult to obtain here. I believe some are using some type of needle, can you give me type and thickness and do you keep the point of flatten it? I would like to keep a few as backup in my van.
Thanks
ChipRite

Re: Needle for making be

Posted: April 16th, 2006, 3:37 am
by phils windshield repair
u can use sewing needles for sewing machines jus make sure to get to get to get a nice heavy duty one been using same one for some 20 odd yrs works great if your not comfortable with that u can order one thru glass mechanix not sure if any other companies offer it or not have only used glass mechanix products in all my yrs in business after reading this forum tho i would be willing to gamble delta also offers some kind of product for this to. hope this helped u

Re: Needle for making be

Posted: April 16th, 2006, 7:47 am
by toab
I think that the ones I have are #18 sewing needles for a sewing machine although they are tricky to use with the tiny fg329 bit.Work good with the 1171 bit though.I have had good luck useing my probe to do it also.

Re: Needle for making be

Posted: April 16th, 2006, 12:41 pm
by ChipRite
Thanks,
I will be switching to FG-701 drills, using FG-2 at the moment. I understand that the needle then just has to be thinner than the hole which in my case is .039"?
Do you keep the sharp point or not?
Thanks
ChipRite

Re: Needle for making be

Posted: April 17th, 2006, 12:15 pm
by glassfixerCO
Yes there's no need to dull the needle. GM sells tappet and needle sets for around $5 (the tappet is a piece of thick plexiglass about the size of a box of matches that you whack the top of the needle with after inserting in drill hole).