bubbles in drill holes
crack resin
Can anybody give me any ideas as to how to get rid of these bubbles. It is so disappointing to do a perfect repair, only to have a bubble come out of no where when curing with the pit resin and not be perfect.
bubbles in drill holes
try using a straight pin to work the bubbles out of the pit resin prior to curing.
Re: bubbles in drill holes
Try keeping your pit resin container upside down at all times including storing.
Pay it foward,
Brian
www.safeglasstechnologies.com
[email]"info@safeglasstechnologies.com"[/email][/email]
Pay it foward,
Brian
www.safeglasstechnologies.com
[email]"info@safeglasstechnologies.com"[/email][/email]
Re: bubbles in drill holes
Avoid shaking your pit fill resin, as this can also cause bubbles in it.
re: bubbles in drill holes
I do tip the pit resin upside down in the winter, but in the summer with the resin warming up in the bottle, when I unscrew the cap after being upside down, it oozes out and makes a mess, not to mention losing resin. I don't have to even squeze the bottle and it spill out
Where do you get your pit resin from?
Thank for your input
rp
Where do you get your pit resin from?
Thank for your input
rp
bubbles in drill holes:befenne
Delta Kits Resins Only. When you actually use the resin the bottle does not actually have to be upside down. You can hold it on an angle. Just return the bottle to an upside down position. Also don't keep your resins in direct sunlight and keep them coverd. This might help somewhat with the oozing.
Pay it foward,
Brian
www.safeglasstechnologies.com
[email]"info@safeglasstechnologies.com"[/email][/email]
Pay it foward,
Brian
www.safeglasstechnologies.com
[email]"info@safeglasstechnologies.com"[/email][/email]
Re: bubbles in drill holes:befenne
Do you cure with a lamp or with sunlight?
"education is power"
"education is power"
Re: bubbles in drill holes
Most of the time I cure with sunlight. Whenever I can anyway
bubbles in drill holes
I use a UV lamp.
Pay it foward,
Brian
www.safeglasstechnologies.com
[email]"info@safeglasstechnologies.com"[/email][/email]
Pay it foward,
Brian
www.safeglasstechnologies.com
[email]"info@safeglasstechnologies.com"[/email][/email]
Re: bubbles in drill holes
Ok.. I've seen a couple of responses that are ok.. But, how about:
A: Use less injector head pressure against the glass. (Do not overtighten injector to windshield) You only need it to seal. Overtightening and curing can cause the shot to actual suck in air after the injector is removed and the windshield tries to regain its natural plane..
B: Use a smaller drill bit. Jan-Vil sells some that are about half the size of others marketed. The results are a less obtrusive drill hole. A less visible repair. And the smaller the hole, the less chance of air re-accumilating in it.
A: Use less injector head pressure against the glass. (Do not overtighten injector to windshield) You only need it to seal. Overtightening and curing can cause the shot to actual suck in air after the injector is removed and the windshield tries to regain its natural plane..
B: Use a smaller drill bit. Jan-Vil sells some that are about half the size of others marketed. The results are a less obtrusive drill hole. A less visible repair. And the smaller the hole, the less chance of air re-accumilating in it.
Who is online
Users browsing this forum: No registered users and 10 guests