Windshield Repair Forum

Is anybody using the DK Led inspection light? If so what do you think of it? Does it serve its purpose in poorly lit areas?

I'm struggling when working inside the unit and the customer only has one flourescent tube light above the vehicle. Can't really tell if the damage is ready to be cured or not?

Thanks in advance

I did demo these lights before they were released and now own and they work great for more focused lighting. If you want broad coverage, this is not the right light. For DK tooling, I have found the best way for me to attatch the light to the bridge is off to either side of the vacuum pump on the base(there is enough room and the spring loaded light clamp it will slide right on and is more stable), then swing the light around and down on the damage as required.

The attatchment clamp is non DK specific so most should have no problem using regarless of eqip. brand.