Windshield Repair Forum

HI all, just a quick question about injector seals:

Using the white rubber seals and on one end there is a small indent tab. Does that go up into the injector when you replace it or does it go the other way? What is the reason for the indent?

Did some searches and only found 1 post on this topic.

Thanks

Please fill out your profile so you can benefit the most from other forum members.

I will assume you are using DK tooling. The side with the small mold detent goes up into the injector. This detent is from the mold more than likely.

DK's new tip seals are stamped on the top of the seal and tis is the side that should also go up into the injector as well.

SGT;24611 wrote:DK's new tip seals are stamped on the top of the seal and tis is the side that should also go up into the injector as well.

Said new seals are a leap in the right direction! They're tougher and more resilient than the old outfit.