Hi Pommy,pommy wrote:Oh no!
I should have said, sorry.
A thumb nail sized blob, spread onto it should be enough per side.
Re-misting the pad and the lens with water is important too.
I normally go hard over the whole lens - side handle slightly up, not at the normal right angle. I use my left leg to control the drill.
I'll wipe off after that and check for grey areas and hit them again if there are any.
In this case, slow and steady wins the race
Cheers,
Pommy
Kind of new to this set-up. So you sand off just the old peeling coating to a masked off line up to 1500. Then use this GT Glass compound to blend the sanded part to match the oem coating that is still good. Clean off all of the compound and coat the entire lens with Infinity? Or do you compound the whole lens prior to Infinity coating?
Sorry for the confusion. I'm just trying to wrap my brain around this. Right now I'm having to sand ALL of the oem coating off prior to coating.
Aj