Pump in VAC
-
- Junior Member
- Posts: 8
- Joined: June 30th, 2009, 8:11 pm
- Enter the middle number please (3): 3
- Contact:
Pump in VAC
Does pumping in vac help? I'm pretty sure someone's tried it.
-
- Senior Member
- Posts: 771
- Joined: December 13th, 2005, 9:01 am
- Enter the middle number please (3): 5
- Location: Europe / US
- Contact:
Re: Pump in VAC
Mhh, what type of system are you using?
-
- Junior Member
- Posts: 8
- Joined: June 30th, 2009, 8:11 pm
- Enter the middle number please (3): 3
- Contact:
Re: Pump in VAC
DK... (B300)
- Brent Deines
- Moderator
- Posts: 2449
- Joined: September 24th, 2003, 7:54 am
- Enter the middle number please (3): 5
- Location: Eugene, OR
- Contact:
Re: Pump in VAC
Some techs do it all right, but we have never found it to be effective and don't recommend it.
Brent Deines
Delta Kits, Inc.
Delta Kits, Inc.
- Mr Bill
- Senior Member
- Posts: 523
- Joined: February 9th, 2005, 6:15 pm
- Enter the middle number please (3): 5
- Location: Santa Cruz CA
- Contact:
Re: Pump in VAC
Please explain further, what you mean.
On a DK injector?
On a DK injector?
-
- Junior Member
- Posts: 8
- Joined: June 30th, 2009, 8:11 pm
- Enter the middle number please (3): 3
- Contact:
Re: Pump in VAC
what i mean is when you go to the vacuum cycle you do any of you pump up and down a couple times before locking the injector in vacuum mode
Re: Pump in VAC
It is physically impossible to "pump in vacuum" (physics 101) You can pump in air but you can not pump vacuum .
Re: Pump in VAC
harrellbenjamin wrote:It is physically impossible to "pump in vacuum" (physics 101) You can pump in air but you can not pump in vacuum .
Re: Pump in VAC
You guys are confusing me! I use Poly Lite vacuum preasure pump it's a fine system. I use it on the bigger cracks and chips and for long cracks in preasure mode it was great with vasoline on the suction cups so I can slide it along the crack. A star chip it works good especialy in vacuum mode it pulls all the air out, than put it in preasure mode and pushes the resin in the chip. For normal chip/cracks I still use my trustee wedge with a piston.
Re: Pump in VAC
I have only done 80 - 100 repairs and in no way am I commenting as an expert .But I believe I tried pumping my DK in order to remove small bubbles in a combo { after 1st or 2nd pressure cycle I held bridge in place and lifted plunger up and down several times to try to dislodge air . Is that what you meant ? } It did work but Brent and Kori are the Masters and from reading in this forum he has repeatedly said just work the cycles and I have stopped trying to speed up the process and let the equipment do the work .I am some what impatient and have found if I repeat cycles the affect is the same . During the same time in my self instruction tried to apply pressure to speed up and created a beautiful daisy .LOL . I am Patiently waiting for DK training in my area to kick off and start making some money . If I said anything here that is wrong I am open for correction .
Who is online
Users browsing this forum: No registered users and 12 guests