Nasty! Nasty!

Post your windshield repair tips, questions, advice! Note there is a sub-forum specifically for business development questions.
Post Reply
GLASSTIME
Member
Posts: 408
Joined: January 26th, 2009, 4:28 pm
Enter the middle number please (3): 5
Location: Gaston, North Carolina

Nasty! Nasty!

Post by GLASSTIME »

Just wanted to share these photos with you guys! This was on a 2004 Toyota Avalon / State Farm Client $0 Deductible, that's the first! Ha!
Attachments
image.jpg
image.jpg (21.89 KiB) Viewed 4335 times
image.jpg
image.jpg (21.38 KiB) Viewed 4335 times
Chad E. Clewis
President
GLASSTIME Windshield Repair & Headlight Restoration


"Its What You Put Into It That Counts"
Image
screenman
Senior Member
Posts: 3192
Joined: February 25th, 2004, 1:44 pm
Enter the middle number please (3): 5
Location: uk Lincolnshire

Re: Nasty! Nasty!

Post by screenman »

Nasty but lovely and clean.
GLASSTIME
Member
Posts: 408
Joined: January 26th, 2009, 4:28 pm
Enter the middle number please (3): 5
Location: Gaston, North Carolina

Re: Nasty! Nasty!

Post by GLASSTIME »

Thank you sir! :P
Chad E. Clewis
President
GLASSTIME Windshield Repair & Headlight Restoration


"Its What You Put Into It That Counts"
Image
bill lambeth
Senior Member
Posts: 565
Joined: September 17th, 2007, 4:29 pm

Re: Nasty! Nasty!

Post by bill lambeth »

14u2ponder wrote:
GLASSTIME wrote:Thank you sir! :P
I am sorry but I do not like this statement. You need to grow up!

I don't think screenman meant it the way you think he did. That chip you showed in the first pic is a repairman's dream chip. It looks fresh with no dirt in it. These chips make for a dramatic reveal once repaired, often you can get them to look nearly invisible. In your case, it looks like there's still very visible lines in all directions, so it might not be the greatest repair job in the world.
User avatar
Eco Steam
Member
Posts: 204
Joined: October 17th, 2006, 4:00 pm
Enter the middle number please (3): 5
Location: Austin, Texas
Contact:

Re: Nasty! Nasty!

Post by Eco Steam »

14u2ponder wrote:
GLASSTIME wrote:Thank you sir! :P

I don't think screenman meant it the way you think he did. That chip you showed in the first pic is a repairman's dream chip. It looks fresh with no dirt in it. These chips make for a dramatic reveal once repaired, often you can get them to look nearly invisible. In your case, it looks like there's still very visible lines in all directions, so it might not be the greatest repair job in the world.
14u2ponder,

The damage is pretty big and extensive, and he did a very good job with repairing it. When it comes to chips, we all know and have learned, that there will ALWAYS be some sort of visual imperfection. If you're going out and repairing windshields with 100% clarity, you're one of a kind and maybe you need to start training people on your break through technique!

Way to go with the half glass empty approach!

GlassTime,

You did a superb job with the repair, it's good to see that you're back up and running again, keep up the good work!

ATX
maxryde
Member
Posts: 476
Joined: December 3rd, 2003, 1:00 pm
Enter the middle number please (3): 5
Location: Panama City Beach, Florida

Re: Nasty! Nasty!

Post by maxryde »

Well Put ATX, Nice work Glass Time!!
User avatar
Eco Steam
Member
Posts: 204
Joined: October 17th, 2006, 4:00 pm
Enter the middle number please (3): 5
Location: Austin, Texas
Contact:

Re: Nasty! Nasty!

Post by Eco Steam »

I think you are reading far too much into my post. I think you believe that I am bragging about my skill as a repairman, which I am not. In addition, that I am putting a fellow windshield repairman down. Neither is the case. What I AM doing is trying to explain screenman's comment to the OP because I felt that he misinterpreted it as a compliment to his repair job, which I don't think it was.

From my point of view, I don't consider the previous picture as a "nasty" chip, but rather (like screenman, I assume) I think of nasty dings as ones with, say, two or more individual chips running into each other, a chip with a huge pit (a dime in width or more) and smashed glass, or a chip that's delaminated due to age, or dirt-filled.
Each technicians interpretation of a bad repair is just that, who am I to say yours or glasstimes or screenmans or anyone's else is worse than the others?

Since I can actually physically see because of the pictures, this was a pretty bad chip with an awesome repair job, that's my interpretation.

There's nothing out there that states if you have 2 conjoining chips with a large dime sized smashed glass center, this is classified as a really bad chip!

As for breaking down a 5 word comment and assuming what that person was saying, why? What's the purpose of it?

Since you clearly have an answer/comment for everything, what was your goal with this part of your statement? Is this your way of critiquing the repair job?:
In your case, it looks like there's still very visible lines in all directions, so it might not be the greatest repair job in the world
An assumption is just that, and there is a saying about making assumptions!
Last edited by Eco Steam on October 21st, 2012, 7:29 am, edited 1 time in total.
User avatar
Eco Steam
Member
Posts: 204
Joined: October 17th, 2006, 4:00 pm
Enter the middle number please (3): 5
Location: Austin, Texas
Contact:

Re: Nasty! Nasty!

Post by Eco Steam »

Ok...I fixed the last post....
GLASSTIME
Member
Posts: 408
Joined: January 26th, 2009, 4:28 pm
Enter the middle number please (3): 5
Location: Gaston, North Carolina

Re: Nasty! Nasty!

Post by GLASSTIME »

14u2ponder wrote:
GLASSTIME wrote:Thank you sir! :P

I don't think screenman meant it the way you think he did. 14U2Ponder, first and foremost wether Screenman meant that in a positive or negative way would be for him to say and no one else, Hence: he's the one who wrote it....right? I took it as a "Positive" statement, so being a receptive individual I said "Thank you sir" That chip you showed in the first pic is a repairman's dream chip. Exactly what is a "Repairmens Dream Chip" to me, any damage to a Windshield would be a "Dre Chip"..Why? Well that's simple, I love what I do, I make every effort to delivery OPTIMAL results! Is that a crime? Is it so bad that one can't share a photo of ones work w/o the negativity of others? It looks fresh with no dirt in it. I'm sorry, how rude of me! I had no idea you were there as I was performing this repair...actually, you could say it was fairly new if four months falls in there for your observation . I I was factory trained by Delta, I stick to ROLAGS, I've learned my trade inside and out....I would only expect NOTHING less than what's before your eyes, yes, it is CLEAN, I cleaned it again, my training! :) These chips make for a dramatic reveal once repaired, often you can get them to look nearly invisible. As a matter of fact, that's my ultimate goal with every repair I encounter, call it luck, this one turned out phenomenal! I was very pleased with the outcome, to bad you can't see the same! In your case, it looks like there's still very visible lines in all directions, Please share with us all you're secret, that statement makes us believe that you're repairs are completely invisible, of course you can still see "Lines", they're called "Legs" (just industry lingo), with any repair you still may see the damage from different angles of light, the goal should be at least a 85% or better improvement than its original state (learned that stuff in training too) so it might not be the greatest repair job in the world.
ATX_Windshield_Repairs wrote:
14u2ponder wrote:
GLASSTIME wrote:Thank you sir! :

14u2ponder,

The damage is pretty big and extensive, and he did a very good job with repairing it. When it comes to chips, we all know and have learned, that there will ALWAYS be some sort of visual imperfection. If you're going out and repairing windshields with 100% clarity, you're one of a kind and maybe you need to start training people on your break through technique!

Way to go with the half glass empty approach!

GlassTime,

You did a superb job with the repair, it's good to see that you're back up and running again, keep up the good work!

ATX
ATX,

Thanks for the positive outlook! Thinking outside the box sometimes is nearly impossible for some, and it's great to be back in action and on the forum....where I belong, gotta help my brothers...and sisters! Right!

Hey MaxRyde,

How you been? Thanks pal!
Chad E. Clewis
President
GLASSTIME Windshield Repair & Headlight Restoration


"Its What You Put Into It That Counts"
Image
maxryde
Member
Posts: 476
Joined: December 3rd, 2003, 1:00 pm
Enter the middle number please (3): 5
Location: Panama City Beach, Florida

Re: Nasty! Nasty!

Post by maxryde »

Hey, yall,

"Hey MaxRyde,

How you been? Thanks pal!"

I've been doing ok. I moved to fla a couple years back and went to work full time. I am shifting into WSR full time again.

Thanks, Scott
Post Reply

Who is online

Users browsing this forum: Bing [Bot], Google [Bot] and 2 guests