drill every point of a star break?

Post your windshield repair tips, questions, advice! Note there is a sub-forum specifically for business development questions.
Post Reply
manocao
Junior Member
Posts: 1
Joined: June 14th, 2018, 11:15 pm
Enter the middle number please (3): 3
Has thanked: 0
Been thanked: 0

drill every point of a star break?

Post by manocao » June 15th, 2018, 3:46 am

hi, i had this star in my windshield
star.jpg
once repaired it looks like this, it's a 5 point star
repaired.jpg
but because of severe changes of temperature and pressure due to driving mountains up and down, i see cracks are spreading and i guess they won't stop and will get worse, now it is 1 inch diameter
do you think i could drill every 5 point of the star to stop spreading? something like this,
drill.jpg
thanks 4 answers!
You do not have the required permissions to view the files attached to this post.

ghost rider
Member
Posts: 157
Joined: April 16th, 2008, 5:04 am
Enter the middle number please (3): 5
Location: Iowa
Has thanked: 1 time
Been thanked: 17 times

Re: drill every point of a star break?

Post by ghost rider » June 15th, 2018, 6:09 am

My guess would be it wasn't dried out good enough before it was repaired. That's why you see the ends of the cracks re-opening. Moisture was left in the ends of the cracks. If a dry-out was done it's possible the glass wasn't cooled enough before filling. Either way a poor quality repair. You could drill the points and try to back fill them but it's probably not going to look very good with 5 more drill holes and you still have the moisture problem. If a customer brought this to me I would say wait till it cracks out and buy a new windshield.
These users thanked the author ghost rider for the post:
screenman (June 24th, 2018, 12:37 pm)
Rating: 25%

denniscraven
Junior Member
Posts: 3
Joined: May 25th, 2018, 1:06 pm
Enter the middle number please (3): 3
Location: KICT
Has thanked: 0
Been thanked: 0
Contact:

Re: drill every point of a star break?

Post by denniscraven » October 5th, 2018, 2:21 am

Stars are the most challenging for me. First my resin of choice is a low CPS or viscosity. Second is patience, those legs must fill. Some massage the star from the inside to help the resin move (while under pressure). I'm big on creating bullseye to help 'ventilate' the break. But the most important to me is low viscosity/patience.
Dennis Craven
THE CRACK CAT
(316)393-5734

Post Reply

Who is online

Users browsing this forum: No registered users and 2 guests