Delta Kits Seals

[optic-kleer]

Good Morning
This old question has reared it's ugly head once again. I have had a few queries regarding the hardness of Delta seals. I am refering to the white ones that seem extremely hard for the first half dozen or so uses. Up till now I usually recommend either using the tip of the injector piston to help loosen them up a bit or even on occasion leaving them for a few hours in a pot of resin. Both help a little but I would be interested to know what others find works best.
Regards
Eric Howe
Optic-Kleer
England

[DaveC]

Eric,

When I first started "practicing" my repairs with my new Delta equipment, I coud not, for the life of me, figure out why resin wasn't flowing into the damaged area!!!

Well, a little trial and error and I was able to realize what was discussed in the following thread ....

viewtopic.php?t=558&highlight=seal+tab