Question

[ClearView WRS]

I had a question on how much resin you put into the injector. I know it depends on the size of the damage, but I

[Delta Kits]

Which system do you use?

How much resin do you currently use?

If our system, we recommend seven drops, although we don't recommend counting them as you drop them in since you could have issues with the resin reaching the seal.

What to do?

Couple things.

Our single shots hold .15cc's of resin, enough to do virtually any break. Easy
Or, you can get a reusable syringe and fill it to .15cc's of resin.
On the dropper that comes with bottles, if you fill it just above the taper line, that's approximately 7 drops.

If you use a different system, i'd recommend contacting them for tech support!

Speeeeling

[ClearView WRS]

I use your guy

[Delta Kits]

Halfway is too much. Just go over where the dropper tapers up to it's widest point. As long as you're sticking it down as far down as possible, no problems with using that amount of resin.

Not that I have a problem selling you more resin though

[ClearView WRS]

lol business is business :biggrin:

[Bois]

Hey, ClearView,
I re-use Delta's single shot syringes. They're colored which gives some UV protection (unlike a dropper) - especially on long cracks. After attending 2 Delta training sessions (and keeping the empty syringes) I have a pretty good sense on how much resin to pull up into the syring.

Dale...

[crkdupinga]

I purchased a box of 100 insulin syringes with ultra-fine needles from Sam

[ClearView WRS]

Thank you guys! I think I have an idea now on how much resin to use. Boy... I was using WAY too much resin. Again, thank you all