just wanted to say hay and show off my first job. also to say thanks to Delta and the training they have offered me, it was great and i highly recommend it to every that can make it. lucky for me i am only an hr. away...
Anyway the 2003 Mini Cooper has has some clear or a really really bad restoration at some point as it looked like and felt like the clear coat or UV coating was pored on. It had hi and low spots every where. below is a before and after as well as the first little bit of sanding to show all the hi and lows... sorry i for got to get a before of the driver side but as you can see from the passenger side they where bad and took 1 hr each to complete... also had to go from 320 down to 180 to start
driver side
first start of sanding. you can see the hi and lows from a poorly applied coating of clear or UV and was way to thick.
my first job.
- ctmandu1
- Junior Member
- Posts: 25
- Joined: July 6th, 2012, 3:43 pm
- Enter the middle number please (3): 3
- Contact:
-
- Member
- Posts: 232
- Joined: May 20th, 2012, 1:05 pm
- Enter the middle number please (3): 3
- Location: South Elgin, IL
- Contact:
Re: my first job.
Great work. I have yet to see a Minni Cooper in need of a HLR. So your one up on me. Good luck to you.
Paul Weinstein
-
- Member
- Posts: 476
- Joined: December 3rd, 2003, 1:00 pm
- Enter the middle number please (3): 5
- Location: Panama City Beach, Florida
- Contact:
Re: my first job.
Nice work, GREAT job...
-
- Senior Member
- Posts: 1058
- Joined: April 12th, 2008, 8:47 pm
- Enter the middle number please (3): 5
- Location: U.S.
- Contact:
Re: my first job.
Very Nice!!!
- ctmandu1
- Junior Member
- Posts: 25
- Joined: July 6th, 2012, 3:43 pm
- Enter the middle number please (3): 3
- Contact:
Re: my first job.
thank you.
Who is online
Users browsing this forum: No registered users and 3 guests