delta injector question

clay507 · Post by **clay507** » February 3rd, 2004, 9:42 pm

I am having a problem with the injector. I understand the pressure cycle, but when I pull the injector for the vacuum cycle and lock it into place, the vacuum stops and the bubble is not removed. It seems that the seal is not long enough to pull out the air from the break, and keep the vacuum pressure cycle.

Clay

Post by **Delta Kits** » February 3rd, 2004, 10:17 pm

Clay,

As with most technical questions, it's much easier to diagnose the problem you are having if you call for tech support. There is a lot of information we need to get from you to say with certainty what is causing the problem you are describing.

I realize that you didn't purchase the kit from us, but we will still offer you unlimited technical support. Call us tomorrow at 1.800.548.8332, or email me your phone number and i'll call you.

clay507 · Post by **clay507** » February 4th, 2004, 5:53 am

Thanks Delta for your support.

gt_repair · Post by **gt_repair** » February 4th, 2004, 8:36 am

clay
Just stick your probe or pin in the hole after you put the resin in and that should remove the traped air, then go to vac. / or when you are on a vac. just slide your injector to pull the air bubble out of the hole.

Try that once.

Windshield Repair Forum

delta injector question

Who is online