Page 1 of 1
Posted: February 3rd, 2004, 9:42 pm
by clay507
I am having a problem with the injector. I understand the pressure cycle, but when I pull the injector for the vacuum cycle and lock it into place, the vacuum stops and the bubble is not removed. It seems that the seal is not long enough to pull out the air from the break, and keep the vacuum pressure cycle.
Clay
Posted: February 3rd, 2004, 10:17 pm
by Delta Kits
Clay,
As with most technical questions, it's much easier to diagnose the problem you are having if you call for tech support. There is a lot of information we need to get from you to say with certainty what is causing the problem you are describing.
I realize that you didn't purchase the kit from us, but we will still offer you unlimited technical support. Call us tomorrow at 1.800.548.8332, or email me your phone number and i'll call you.
Posted: February 4th, 2004, 5:53 am
by clay507
Thanks Delta for your support.
Posted: February 4th, 2004, 8:36 am
by gt_repair
clay
Just stick your probe or pin in the hole after you put the resin in and that should remove the traped air, then go to vac. / or when you are on a vac. just slide your injector to pull the air bubble out of the hole.
Try that once.