Drilling technique
-
Jtmac
- Junior Member
- Posts: 29
- Joined: August 10th, 2018, 5:23 pm
- Enter the middle number please (3): 3
Drilling technique
Could someone tell me the significance of starting your drill at 45 degrees and then raising it to 90 after you begin drilling? I've noticed this in several videos.
-
Nomad
- Member
- Posts: 283
- Joined: December 11th, 2004, 3:13 pm
- Enter the middle number please (3): 5
- Location: Yuma Arizona
- Contact:
Re: Drilling technique
It's using the end of the burr to grind a pocket, a little dip in the glass, so that the drill will not skate around when you begin drilling.
-
Jtmac
- Junior Member
- Posts: 29
- Joined: August 10th, 2018, 5:23 pm
- Enter the middle number please (3): 3
Re: Drilling technique
I don't use burr bits, so that explains it. Thanks.
Who is online
Users browsing this forum: No registered users and 21 guests