gm thick resin

Post your windshield repair tips, questions, advice! Note there is a sub-forum specifically for business development questions.
Post Reply
phils windshield repair

gm thick resin

Post by phils windshield repair »

im in michigan for some reason i have 8 ounces of thick resin from gm what is this resin good for and can u also dilute thick resin with starfill ty for your input
GlasWeldTech
Member
Posts: 434
Joined: August 9th, 2003, 3:11 pm
Enter the middle number please (3): 5
Location: West Monroe,La.
Contact:

Re: gm thick resin

Post by GlasWeldTech »

You may want to try it in Bullseyes. Nothing with tight legs in it.
toab

Re: gm thick resin

Post by toab »

Seems to me that the thick stuff is also recommended for crack work due to its inherant higher strength and closer R.I. to glass when cured.I am having some luck starting long cracks with thin resin and then adding the thick stuff to the injector after the first few inches where the crack is easier to fill.But I am just a newbie so the veterans may correct me on my technique.When I was snooping around the internet about the .
dragwurm

Re: gm thick resin

Post by dragwurm »

thick resin is relly used for a high temp repairs. its good for bullseye and combos where the legs dont pass the coned area, :eusa_droo
toab

Re: gm thick resin

Post by toab »

High temp meaning summer time or meaning when using heat on the repair?
phils windshield repair

question

Post by phils windshield repair »

can u thin out gm thick resin ty 4 input?
Post Reply

Who is online

Users browsing this forum: No registered users and 36 guests